Blade into the workpiece. (See Fig- ure T.)
10.
WARNING! Keep hands and fingers safely away from the cut- ting area.
11.Slowly lower the Body Frame (60), while it gradually feeds the Saw Blade (82) into the workpiece. Do not force the Bandsaw to remove mate- rial faster than it is designed to cut.
(See Figure T.)
12.Never attempt to remove mate- rial stuck in the moving parts of the Bandsaw while it is plugged in and running. Turn off the Bandsaw if the workpiece is to be backed out of an uncompleted cut.
13.IMPORTANT: When in the horizontal cutting mode only, the Switch Push- Off Tip (41) will automatically turn the Power Switch (164) to its “OFF” position and shut off the Bandsaw’s Motor when the cut has been com- pleted. (See Figure T.)
14.Once the cut is made, check to make sure the Power Switch (164) is in its “OFF” position. Then, unplug the Power Cord Plug from its electrical outlet. (See Figure T.)
15.Wait until the Saw Blade (82) comes to a complete stop. Next, raise the Body Frame (60) to its full vertical position, making sure it locks in place by turn- ing the Support Plate (150) to the right until it firmly locks into the Body Frame.
Remove the workpiece from the Vise assembly (138, 141) and scrap mate- rial from the Machine Bed (142) of the Bandsaw. Then, slowly lower the Body Frame (60) to its horizontal position and lock it in place with the Locking Pin (115). (See Figure T.)
SKU 93762 | For technical questions, please call | Page 20 |
