Harbor Freight Tools 93762 Figure G, See Figures E, F, and G, See Figure H

Material	Speed	Pulley Groove
	(FPM)	Spindle	Motor
Tool Steel,
Stainless	80	Large	Small
Alloy Steels,
Bearing
Bronze
Medium to High
Carbon Steels,	120	Medium	Medium
Hard Brass or
Bronze
Low to Medium
Carbon Steels,	200	Small	Large
Soft Brass,
Aluminum,
Plastic

2.Refer to the Chart above to deter- mine the proper cutting speed for a specific type of material being cut.

SPINDLE PULLEY	MOTOR PULLEY
LARGE	SMALL
MEDIUM	MEDIUM
SMALL	LARGE

FIGURE G

3.The cutting speed can be adjusted by loosening the Hex Bolt (70) and mov- ing the Motor (81) forward. Place the V-Belt around the desired grooves in the Spindle Pulley (1) and Motor Pul- ley (79). Next, move the Motor back- wards to tighten the tension on the V-Belt. Then, re-tighten the Hex Bolt to secure the Motor in place.

(See Figures E, F, and G.)

4.WARNING! Always securely close the Lid on the Pulley Cover (72) after installing a V-Belt (10) or adjusting the cutting speed.

To Convert The Bandsaw For Vertical Use:

NOTE: Notching, slitting, and contour work is best done with the Bandsaw in its vertical position.

SUPPORT	BODY
PLATE (150)
	FRAME
	(60)
	LOCKING
	PIN (153)

FIGURE H

1.Raise the Saw Head to its full verti- cal position, making sure it locks in position by turning the Support Plate

(150) to the right until it firmly locks into the Body Frame (60) and insert- ing the Locking Pin (153).

(See Figure H.)

SKU 93762 For technical questions, please call 1-800-444-3353. Page 12