5.To lubricate the Worm Gear and Worm Shaft: The Worm Gear (17) and Gear Shaft (19) run in an oil bath Gear Box and should not require an oil change more than once a year, unless the oil becomes contaminated or a leak occurs due to improper replacement of the Gear Box Cover
(14). To change oil in the Gear Box:
a.Position the Body Frame (60) in the horizontal position. (See Figure S.)
GEAR BOX
COVER (14)
6.To clean the exterior parts of the Bandsaw, use only a clean cloth and mild detergent or mild solvent to clean the body of the Saw. Do not immerse any electrical part of the machine in any liquids.
PIVOT (120)
LOCKING PIN (115)
HEX
BOLT (11)
GEAR SHAFT
(19) 
WORM
GEAR (17)
FIGURE W
b. Remove the four Hex Bolts (11), Gear Box Cover (14), and Gear Box Gasket (15). (See Figure W.)
c. Remove the old oil from inside the Gear Box and replace the oil us- ing 140 weight gear oil. The new oil should just come to the edge of the Gear Box. Do not overfill. (See
Figure W.)
d. Replace the Gear Box Gasket (15), Gear Box Cover (14), and four Hex Bolts (11). (See Figure W.)
FIGURE X
7.When the Bandsaw is not in use or when transporting the tool: Al- ways lower the Body Frame (60) to its horizontal position and insert the Locking Pin (115) into the Pivot (120) to secure the Body Frame in place.
(See Figure X.)
8.
CAUTION! All maintenance, service, or repairs not mentioned in this manual must only be per- formed by a qualified service tech- nician.
SKU 93762 | For technical questions, please call | Page 23 |
