Harbor Freight Tools 93762 operating instructions Adjusting The Blade Guide Bearings, Figure S

Adjusting The Blade Guide Bearings:

1.NOTE: Blade Guide Bearings (88, 92, 100, 104) adjustment is a critical factor in the performance of the Bandsaw.

2.It is always best to try a new Saw Blade (82) to see if it will correct poor cutting before attempting to adjust the Blade Guide Bearings. For example, if a Saw Blade becomes dull on one side sooner than the other, it will begin cutting crooked. A Saw Blade replacement will correct this problem, whereas Blade Guide Bearings adjustment will not.

3.If a new Saw Blade does not correct the problem, check the Blade Adjustable Seats (83, 110) to obtain the proper clearance. (See Figure S.)

4.NOTE: There should be from .000” (just touching) to .001” clearance between the Saw Blade and Blade Guide Bearings (88, 92, 100, 104). To obtain this clearance adjust as follows:

A.The Outer Blade Guide Bearings (92, 104) are mounted to Shafts (91, 103) and can be adjusted. (See Figure S.)

B.Loosen the Nuts (86, 96) while holding the Shafts (91, 103) with an Allen wrench (not included). (See Figure S.)

C.Position the Shafts (91, 103) by turning it to the desired position of clear- ance. Then, re-tighten the Nuts (86, 96). (See Figure S.)

D.Adjust the Inner Blade Guide Bearings (88, 100) in the same manner.

OUTER BLADE GUIDE BEARING	SAW BLADE (82)
(92, 104)
		NUT (86, 96)
SHAFT (91, 103)
			(NOT SHOWN)
			INNER BLADE GUIDE BEARING (88, 100)
				SHAFT (91, 103)

FIGURE S

SKU 93762 For technical questions, please call 1-800-444-3353. Page 19