Harbor Freight Tools 93762 operating instructions Adjusting The Blade Guide Brackets, Figure

Adjusting The Blade Guide Brackets:

1.The Right Blade Guide Bracket (90) and Left Blade Guide Bracket (102) are adjustable by loosening the Guide Adjusting Knob (45) and sliding the Brackets up or down to accomodate the depth of the workpiece. (See Figure V.)

2.The Blade Guide Brackets (90, 102) should be set as close as possible to the workpiece, without interfering with the workpiece or contacting the Machine Bed (142). (See Figure V.)

3.Once the adjustment is made, make sure to re-tighten the Guide Adjusting Knob (45). (See Figure V.)

GUIDE ADJUSTING KNOB

(45)

BLADE GUIDE BRACKETS

(90, 102)

FIGURE V

Basic Bandsaw Operation -- Vertical Position:

1.WARNING! Always wear ANSI-approved safety impact eye goggles when operating the Bandsaw.

2.Do not plug the Power Cord Plug into an electrical outlet until all neces- sary adjustments (as previously discussed in this manual) have been made.

3.Raise the Body Frame (60) to its full vertical position, making sure it locks in place by turning the Support Plate (150) to the right until it firmly locks into the Body Frame and inserting the Locking Pin (153). (See Figure W, next page.)

4.Once all necessary adjustments to the Bandsaw have been made, plug the Power Cord Plug into the nearest 120 volt, grounded, electrical outlet.

SKU 93762 For technical questions, please call 1-800-444-3353. Page 22