3.Boards longer than 24” should be supported (on both the infeed and outfeed sides of the Planer) by roller stands (not included). Do not plane boards that are less than 17” long. The force of the cut could split the board and cause kickback.
4.Position the board with its face to be planed on top.
5.Plug the Planer into the nearest 120 volt, grounded, electrical outlet. Then turn on the Planer.
6.Slowly push the board into the infeed side of the Planer. Slide the board into the Planer until the infeed Roller (205) begins to automatically advance the board through the Planer. Release your grip on the board and allow the automatic feed to completely advance the board. Do not push or pull on the board.
7.Move to the rear on one side of the Planer and receive the planed board as it exits the Planer.
8.
CAUTION:
A.Do not stand directly in line with the front or rear of the Planer.
B.Do not grip any portion of the board which has not exited past the outfeed Roller (198).
9.Repeat this operation on all boards which need to be the same thickness.
10.NOTE: The Planer has return Rollers (3) on top of the unit so an assistant can pass the board back to the operator. The assistant must follow the same safety precautions as the operator.
11.When finished using the Planer, turn the Power Switch (14A) to its OFF position and remove the Switch’s Safety Key. Then unplug the Planer from its electrical outlet.
12.Make sure to store the Planer in a clean, dry, safe location out of reach of chil- dren and other unauthorized people.
INSPECTION, MAINTENANCE, AND CLEANING
1.
CAUTION! Always make sure the Power Switch (14A) of the Planer is in its “OFF” position and the unit is unplugged from its electrical outlet prior to per- forming any inspection, maintenance, or cleaning procedures.
2.Before each use, inspect the general condition of the Planer. Check for mis- alignment or binding of moving parts, cracked or broken parts, damaged electri-
SKU 95518 For technical questions, please call
