E.Loosen the two Head Socket Head Screws (159) on the Idler Bracket (156). Then loosen the Chain (52) by sliding the Idler Bracket. (See Figure P.)
F.Carefully rotate the Sprocket (201) by hand to change the Rollercase (136) height. Make sure to leave the other Sprockets untouched. Do not rotate the Sprocket more than one or two teeth. (See Figure P.)
G.Retighten the Chain (52) by securing the Idler Bracket (156) in position. Then tighten the two Head Socket Head Screws (159) on the Idler Bracket (156). (See Figure P.)
H.Set the Planer back on its Base (222). Then make a test cut to verify the adjustment.
5.To clean or replace the Carbon Brushes: It may become necessary to clean or replace the two Carbon Brushes (26A) when the Motor performance de- creases, or stops working completely. The Carbon Brushes are located on each side of the Motor Housing (28A). To do so:
A.Remove the two Brush Caps (25A). Then, remove the two Carbon Brushes from the Brush Holders (27A).
B.If the Carbon Brushes are worn down more than 1/2, replace both Carbon Brushes. If, however, the Carbon Brushes are just dirty they may be cleaned by rubbing them with a pencil eraser.
C.When installing the Carbon Brushes, make sure the carbon portion of the Carbon Brushes contact the Armature (20A) assembly and the springs face away from the Motor. Also, make sure the springs operate freely.
D.After cleaning or replacement, replace the Brush Caps (25A).
E.New Carbon Brushes tend to arc or spark when first used until they wear and conform to the Armature assembly. (See Assy. Diagram.)
6.To clean the exterior/interior of the Planer: Use compressed air. Do not immerse any part of the unit in liquid.
7.
CAUTION! All maintenance, service, or repairs not mentioned in this manual must only be performed by a qualified service technician.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEI- THER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACE- MENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISKS AND LIABILITY ARIS- ING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACE- MENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 95518 For technical questions, please call
