12. Installation requires a 1/2” hole through which to insert the wiring. If your vehicle has no hole of this size, then drilling a hole will be necessary.
3.Select a proper location to mount the Off Road Light and mark it. The Light may be either top or bottom mounted. If there is no hole for mounting your Light, you must drill one at the point you have selected.
4.Attach Positive wire (not included) to the proper terminal near the base of the Off Road Light before the Light is mounted to the vehicle. There is only one, it is easy to locate.
5.Insert Positive wire (not included) and Black Ground Wire (6) through the hole next to where you wish to mount your Light.
Figure 1
Rubber Mounting Pads (7)
Nut & Washer (8)
6.Place one of the Rubber Mounting Pads (7) against the upper and lower sections of the Light mounting hole. Use the Washer and Nut (8) provided to secure the Light snuggly to your vehicle. The Rubber Mounting Pads (7) attached to the base of your Off Road Light help to keep it from vibrating loose when driving on rough terrain. See Figure 1
SKU 95811 | For technical questions, please call | Page |
