Harbor Freight Tools 98676 operating instructions Symbology, Specifications, 25’ 50’ 75’

least the minimum wire size required.

(See Table A.)

4.If you are using one extension cord for more than one tool, add the nameplate amperes and use the sum to determine the required minimum cord size. (See Table A.)

5.If you are using an extension cord outdoors, make sure it is marked with the suffix “W-A” (“W” in Canada) to indicate it is acceptable for outdoor use.

6.Make sure the extension cord is prop- erly wired and in good electrical con- dition. Always replace a damaged extension cord or have it repaired by a qualified electrician before using it.

7.Protect the extension cords from sharp objects, excessive heat, and damp or wet areas.

RECOMMENDED MINIMUM WIRE GAUGE FOR EXTENSION CORDS*

(120/240 VOLT)

NAMEPLATE		EXTENSION CORD
			LENGTH
AMPERES
		25’	50’	75’	100’	150’
(at full load)
0 – 2.0		18	18	18	18	16
2.1	– 3.4	18	18	18	16	14
3.5	– 5.0	18	18	16	14	12
5.1	– 7.0	18	16	14	12	12
7.1 – 12.0		18	14	12	10	-
12.1	– 16.0	14	12	10	-	-
16.1	– 20.0	12	10	-	-	-
TABLE A		* Based on limiting the line
		voltage drop to five volts at

150% of the rated amperes.

Symbology

Double Insulated

	Canadian Standards Association
	Underwriters Laboratories, Inc.
V~	Volts Alternating Current
A	Amperes
n0 xxxx/min.	No Load Revolutions per Minute
	(RPM)

Specifications

Electrical	120 V~ / 60 Hz
	Power Cord: 18 AWG X 3C
Requirements
	9.6 No Load Amps
Lathe Type	Wood Cutting
Motor	1.0 HP
Motor Speed	1720 RPM
Spindle Speeds	670, 840, 1040, 1230, 1480, 1650, 1770,
(RPM)	2100, 2420, 2900
Spindle Taper	MT-2
Spindle Thread	1” Diameter x 8 TPI x 7/8” Long
Headstock	Rotates at 0°, 60°, 90°, 120°, 180°
Adjustments
Tail Stock	2-7/16”
Quill Travel
Tail Stock	MT-2
Quill Taper
Tool Rest Travel	1-7/16”
Swing Over Bed	14-5/8”
Drive Method	Belt & Pulley
Belt Type	0-625 V-Belt
	3mm, 4mm, 6mm Hex Wrenches (1 ea.)
Accessories	Dead Center (Qty. 1)
	Faceplate (Qty. 1)
	Flat Wrenches (Qty. 2)
Net Weight	282.2 Pounds

SKU 98676 For technical questions, please call 1-800-444-3353. Page 8