Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
2.Place the Bed (38) assembly on the two Stand Legs (74, 78). Align the mounting holes in the Bed assembly with the mounting holes at the tops of the two Stand Legs. Secure the Bed assembly to the two Stand Legs using eight Screws (69), eight Spring Washers (75), and eight Nuts (33). Then set the Headstock (1) upon the Bed assembly. (See Figure A.)
ASSEMBLY Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation:
Turn the Power Switch (71) of the Lathe to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
1.NOTE: This product is very heavy (282.2 lb.). The following assembly procedures will require at least two additional personnel and a proper lift- ing device.
HEADSTOCK
(1)
BED
(38)
STAND LEGS
SCREWS (69)(74, 78) SPRING WASHERS (75)
NUTS (33)
FIGURE A
3.To attach the Faceplate (2), use the Push Out Rod (22) and Wrench (47) to firmly thread the Faceplate onto the Spindle (4). To attach a work- piece to the Faceplate, use the four Flat Head Brass Wood Screws (83).
(See Figures B below, and C next page.)
|
| WRENCH | |
|
| (47) | |
PUSH OUT ROD |
| HEADSTOCK | |
(22) |
|
| SPUR |
|
| ||
|
| (3) | |
FIGURE B
FACEPLATE
(2)
SKU 98676 | For technical questions, please call | Page 9 |
