THE 60-SECOND GUIDE - EPM

1 MIC INPUT (XLR)

Connect Microphones here. If you are using a condenser mic, ensure phantom

 

 

power is supplied by pressing the switch at the top of the master section.

 

 

WARNING: Do Not apply Phantom Power before connecting

 

LINE INPUT (¼” Jack)

a microphone.

2

Connect Line level sources here, e.g. Synth, Drum Machine, DI etc.

3

INSERT POINT (¼” Jack)

Connect Signal processors here, e.g. Compressor, Gate etc.

4 GAIN CONTROL

Adjust this to increase or decrease the level of the incoming signal.

5

EQ STAGE

Adjust these controls to change the signal tone (the character of the signal).

6 AUX 1/2 SENDS

Adjust these controls to change the level of the signal to an artist’s monitors

 

 

(headphones/in-ear/stage monitors). Each Aux is globally switchable pre/

 

 

post fade.

7 PAN CONTROL

Use this control to position the signal within the stereo field.

8 MUTE SWITCH

When this is pressed you will hear no signal from the channel (post-mute

 

 

signals).

9

PFL

When pressed the signal will appear on the monitor and headphone outputs

 

 

- use this to monitor the post-EQ signal from the channel.

10

Soundcraft EFX/EPM User Guide Issue 1210

Page 12
Image 12
Harman 1210KA manual SECOND Guide EPM, AUX 1/2 Sends, Pfl