Track to MIX, Monitor 2 Track, Monitor Level | Harman 1210KA

6 RECORD OUTPUTS

These two RCA outputs carry a copy of the MIX L and MIX R signals. They

allow the use of a recording device, e.g. DAT player, Minidisc recorder etc.

7 2 TRACK IN

These two RCA phono sockets are unbalanced Left and Right line-level inputs, used for connecting a playback device.

8 2 TRACK TO MIX

Press this switch to route the 2 Track in signals, connected to the Left and Right RCA sockets 7, to the MIX .

9 MONITOR 2 TRACK

Press this switch to route the 2 Track signal to the monitor and phones, over-riding the default Monitor/Phones signal.

10 MONITOR LEVEL

This control sets the level to the MONITOR LEFT & RIGHT outputs. If headphones are plugged into the PHONES jack, the headphone level will track the Monitor Level.

11 MONITOR OUTPUTS

The Monitor Outputs are on 3-pole ‘A’ gauge jacks and are balanced connections.

12 PHONES LEVEL

This control sets the output level to the Headphone outputs. If headphones are plugged into the PHONES jack, then the knob sets a comfortable headphone listening level without affecting the Moni- tor output levels.

13 HEADPHONES JACK

The PHONES output is a 3-pole ‘A’ gauge jack, wired as a stereo output as shown, ideally for headphones of 150Ω or greater. 8Ω headphones are not recommended.

14 AUX 1 OUTPUT (AND AUX 2 ON EPM)

This output is on a 3-pole ‘A’ gauge jack and is an impedance-balanced output.

15 AUX 1 PRE/POST SWITCH (AND AUX 2 ON EPM)

This switch globally switches the AUX 1 sends, on all of the input modules, to be either pre-fade or post-fade.

Soundcraft EFX/EPM User Guide Issue 1210

25

Image 27

Harman 1210KA manual Track to MIX, Monitor 2 Track, Monitor Level, Monitor Outputs, Phones Level, Headphones Jack

Contents

User Guide Soundcraft EFX/EPM User Guide Issue User Guide EPM Models Contents Safety Symbol Guide Important Safety Instructions Neutral Blue US White Live Hot Brown US Black Introduction Advice for Those WHO Push the Boundaries 60-SECOND Guide EFX Overview Main Meters Phantom PowerPeak LED Master Faders 60-SECOND Guide EPM AUX 1/2 SendsPFL Mono OUT ¼ Jack 22 2-TRACK Inputs23 2-TRACK Controls Insert Point Wiring UPMic Input Line Input Aux & FX Bus Outputs Stereo Inputs Stereo 1/2 and StereoMix Inserts Mix Outputs Headphones Polarity PhaseGrounding and Shielding Problem Solving Products Under Warranty OUT-OF-WARRANTY ProductsIf in doubt please contact Soundcraft customer support Block Diagram Soundcraft EFX Block Diagram Soundcraft EPM Gain Mono Input Channel EFX shown HF EQ MID EQLF EQ Input Channel Fader Aux 2 Send EPM onlyPAN Mute MF EQ Gain control sets the level of the channel signalInputs Stereo 1/2 Gain Balance FaderChannel Peak LED Soundcraft EFX/EPM User Guide Issue Bargraph Meters Power IndicatorMaster Section EFX MIX OUTPUTS, Inserts & Mono Output Track to MIX Headphones JackAUX 1 PRE/POST Switch and AUX 2 on EPM Track Stereo Return Level EFX only Footswitch EFX onlyFX BUS Output EFX only Aux 2 on EPM Stereo Return Inputs EFX only FX Operation Select and Load a ProgramSet Audio Levels FX Processor Controls EFX only Reverbs Karaoke Reverb Controls Delays Modulated Effects Delay Controls Vibrato PhaserFlanger Tremelo/Pan Factory Reset Effects Data Chart EFX only Using Your EFX or EPM Console Microphone PlacementInitial Setup Page Applications Application 3 Places of Worship using EFX Application 4 Recording Soundcraft EFX/EPM User Guide Issue Glossary Band Distort the signalPhase Peaking Typical Connecting Leads Soundcraft EFX/EPM User Guide Issue Soundcraft EFX/EPM User Guide Issue Karaoke MARK-UP Sheets EPM Soundcraft EFX/EPM User Guide Issue Part numbers for the kits are Fitting Optional Rackmount Ears Soundcraft EFX/EPM User Guide Issue EPM/EFX Typical Specifications Soundcraft EFX/EPM User Guide Issue Benefit of this Warranty may not be assigned by the End User Warranty Soundcraft EFX/EPM User Guide Issue Soundcraft EFX/EPM User Guide Issue Page Balboa Boulevard Soundcraft Soundcraft USA