Harman-Kardon 347 owner manual Resetting the Remote Memory

Programming the Remote

Resetting the Remote Memory

As you add components to your home-theater system, occasionally you may wish to totally reprogram the remote control without the confu- sion of any commands, macros or ”Punch- Through“ programming that you may have done. To do this, it is possible to reset the remote to the original factory defaults and command codes by following these steps. Note, however, that once the remote is reset, all commands or codes that you have entered will be erased and will need to be re-entered:

1.Press any of the Input Selector buttons 4 and the ”O“ button H at the same time until the Program Indicator 2 begins to flash amber.

2.Press the ”3“ button H three times.

3.The red LED under the Input Selector 4 will go out and the Program Indicator 2 will stop flashing and turn green.

4.The Program Indicator 2 will remain green until the remote is reset. Note that this may take a while, depending on how many commands are in the memory and need to be erased.

5.When the Program Indicator 2 goes out, the remote has been reset to the factory settings.

ENGLISH

PROGRAMMING THE REMOTE 57