Harman-Kardon 950-0321-001 owner manual position as you rotate it on the mount

BDS

Mounting Options for Satellite and Center Speakers

4.Attach the wall portion of the wall-mount bracket onto the wall using hardware that is appropriate for the wall’s construction and materials. We recommend first anchoring the bracket using its keyhole, then attaching it with another anchor through its top opening, as shown in the illustration. The satellite speakers weigh 3.3 lb (1.5kg). Be sure to use hardware that can support this weight.

Top Opening

Keyhole Opening

Bottom Opening

NOTE: If you’re running the speaker wire through the wall, you can bring it out directly behind the bracket location and insert it through the bottom opening in the wall portion of the bracket, as shown in the illustration. This move will keep the wire completely hidden from view once the installation is complete.

Insert Wire into

Bottom Opening

Bring Wire Out

Through Here

5.If you’re not running the speaker wire through the wall, insert it through the wall portion of the wall-mount bracket as shown in the illustration.

CAUTION: Before making speaker connections, be sure that the BDS receiver is turned OFF and, preferably, its AC cord is unplugged from the AC outlet.

8. Connect the speaker wire to the speaker terminals as shown in the illustration:

A. Push Down on Cap	B. Insert Bare Wire	C. Release Cap
to Open Hole	into Open Hole	to Secure Wire

+ –

Colored Band

to Red Terminal

IMPORTANT: Make sure the (+) and (–) bare wires do not touch each other or the other terminal. Touching wires can cause a short circuit that can damage your receiver or amplifier.

9.Slide the speaker portion of the wall-mount bracket onto the speaker as shown in the illustration below. Fit the grooves on the bracket onto the rails in the speaker, and apply even pressure on both sides of the bracket so it slides straight onto the speaker.

t Push the bracket all the way onto the speaker until it snaps into place.

t Pull any slack speaker wire back through the bracket as you slide the bracket onto the speaker.

Fit Bracket Grooves onto Speaker Rails

Push Down Evenly on Both Sides of Bracket

6.Pass the speaker wire through the speaker portion of the wall-mount bracket as shown in the illustration.

Bring Wire In

Through Here

Bring Wire Out

Through Here

7.If you have not already removed the speaker’s base, do so by pulling it straight off the speaker, as shown in the illustration. Applying even pressure to both sides of the base will allow it to slide off smoothly.

10.Slide the speaker onto the bracket’s wall section as shown in the illustration. Pull any slack speaker wire back through the bracket’s wall section.

Slide Speaker onto Bracket

Apply Pressure Evenly to Both	Lift Base Straight off Speaker
Sides of Base		11. Fit the metal stop plate into the recess on the bottom of the bracket with the pad facing
		the bracket, and fasten it to the bracket using two of the supplied screws. Fastening it
		will prevent the speaker from detaching from the bracket and will hold the speaker’s
		position as you rotate it on the mount.

Stop Plate

Supplied Screws

12