JVC CA-UXJ55MD Basic and Common Operations, Setting the Clock, To change the clock again, English

English

Basic and Common Operations

Setting the Clock

Before operating the unit any further, first set the built-in clock. When you plug in the power cord, “0:00” starts flashing on the display.

You can set the clock when the unit is either turned on or on standby (off). You cannot set the clock if the unit is on Power Save mode (see page 10).

To change the clock again

On the remote control ONLY:

Press CLOCK/TIMER repeatedly until the clock setting screen appears on the display.

The hour digit starts flashing. Then, perform steps 2 and 3 in “Setting the Clock” again.

CLOCK/

TIMER

On the remote control ONLY:

1 Press CLOCK/TIMER.	TIMER
	CLOCK/

The hour digit starts flashing on the display.

2 Press ¢ or 4 repeatedly GROUP SKIP	GROUP SKIP
to adjust the hour, then
press SET.

The minute digits start flashing on the display.

SET

• Each time you press ¢ or 4, the hour digit(s) change(s) continuously.

•If you want to correct the hour again, press CANCEL. The hour digit(s) start(s) flashing again.

To check the clock time with tones

When the key-touch tone is activated (see “Turning On/Off the Key-touch Tone” on page 10), the unit lets you know the time using long and short tones in different pitches ONLY while the unit is on standby (off).

On the remote control ONLY:
Press DIMMER while the unit is on standby	DIMMER
(off).

“DIMMER OFF” appears, then the clock time is shown on the display with tones.

The time is represented by a four-digit number: two digits each for hours and minutes (ex. 2:58 = 0258).

Each digit is distinguished by a different pitch of tone, and numbers are made up of long and short tones.

The following shows the details.

Differentiation of digits:

3 Press ¢ or 4 to adjust the minute, then press SET.

The built-in clock starts.

Do Mi Sol Do

•Each time you press ¢ or 4, the minute digits change continuously.

•Adjusting the hour and minute using the number buttons in steps 2 and 3

Ex.: To adjust the hour/minute to 5, press 5.

To adjust the hour/minute to 12, press +10, then 2.

To adjust the hour/minute to 20, press +10, then 10 (or press +10 twice, then 0).

•When you unplug the power cord or if a power failure occurs

The clock is reset to “0:00” right away. If this happens, set the clock again.

•The clock may gain or lose 1 to 2 minutes per month If this happens, reset the clock.

	Higher hours digit			Higher minutes digit
		Lower hours digit				Lower minutes digit
Representation of numbers:
	Numbers		0	1	2		3	4
	Tones		—	-	--		---	----
	Numbers		5	6	7		8	9
	Tones		•••••	•••••-	•••••--		•••••---	•••••----
	* •••••: Five quick short tones
Ex.:				Hours			Minutes

—	--	•••••	•••••---
Do	Mi	Sol
			Do

9