JVC GVT0104-002A Listening to FM and AM Broadcasts, Tuning in to a Station, On the unit ONLY

English

Listening to FM and AM Broadcasts

Setting the AM Tuner Interval Spacing

Some countries AM channel intervals are set to 9 kHz apart, and some countries use 10 kHz apart.

When shipped, the built-in AM tuner is set to 9 kHz spacing. You can change the channel interval to 9 kHz or 10 kHz spacing.

On the unit ONLY:

To set the AM tuner to the 10 kHz spacing, be sure that the unit is turned off (on standby), but is plugged into a wall outlet.

Press (standby/on) while holding ¢. The unit turns on and tunes in to 530 kHz.

¢UP

To set it back to the 9 kHz spacing, be sure that the unit is turned off (on standby), but is plugged into a wall outlet.

Press (standby/on) while holding 4. The unit turns on and tunes in to 531 kHz.

4DOWN

2 Press and hold ¢or 4for more than 1 second.

GROUP SKIP	GROUP SKIP
	4DOWN	¢UP

(On the remote control) (On the unit)

•¢: Increases the frequencies.

•4: Decreases the frequencies.

The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in.

•If an FM program is broadcast in stereo, the STEREO indicator lights up on the display (only when the reception is good).

To stop during searching, press ¢or 4.

When you press ¢or 4repeatedly

The frequency changes step by step.

To change the FM reception mode

When you change the AM channel interval spacing

The preset stations you have set (both FM and AM) will be erased. In this case, preset stations again. See “Presetting Stations” on page 14.

Tuning in to a Station

1 Press FM/AM/AUX (or FM/AM on the unit) to select either “FM” or “AM.”

FM/AM	AUX/DVD
/AUX
	FM/AM

(On the remote control) (On the unit)

The unit automatically turns on and tunes in to the previously received station—either FM or AM.

•Each time you press the button, the band changes as follows:

On the remote control:

FM AM AUX*

*For operating the external equipment, see page 27 and the manuals supplied with it.

On the unit:

FM AM

When an FM stereo broadcast is noisy or hard to receive, you can change the FM reception mode to improve the reception.

On the remote control ONLY:

Press FM MODE so that the MONO indicator	FM
lights up on the display.	MODE

To restore the stereo effect, press FM MODE again so that the MONO indicator goes off. In stereo mode, you can hear stereo sound when a stereo program is broadcast.

•The STEREO indicator lights up only when the reception is sufficient.

13