English
Message |
| Signification |
Solution
MD NO DISC
NON AUDIO (or DVD)
CAN NOT COPY
PLAY BACK
DISC
READ ERROR
SCMS CANNOT
COPY
There is no MD.
You are trying to copy a
The UTOC fails to be read.
Digital copy of the 2nd generation is prohibited.
Put an MD.
Stop recording.
Use a recordable MD.
Turn off the unit, then turn on it again. You cannot make a digital recording from a duplicated
Troubleshooting
If you are having a problem with your unit, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person, such as your dealer, for service.
Symptom
Power does not come on.
Operations are disabled.
No sound is heard.
Possible Cause
The power cord is not connected to an AC outlet.
The
•Connections are incorrect or loose.
•A pair of headphones is connected.
Action
Insert the plug into the socket.
Unplug the AC power cord then plug it back in.
• Check all connections and make |
corrections. (See pages 6 to 8.) |
• Unplug the headphones from the |
PHONES jack. |
Unable to operate the unit by the remote control.
Hard to listen to broadcasts because of noise.
Loaded discs, MD, and cassette cannot be ejected.
The disc does not play.
The CD skips.
Unable to record on an MD.
Impossible to record on a tape.
•The path between the remote control and the remote sensor on the unit is blocked.
•The batteries are exhausted.
•You are using the remote control too far from the unit.
•Antennas are disconnected.
•The AM loop antenna is too close to the unit.
•The FM antenna is not properly extended and positioned.
•The AC power cord is not plugged in.
•The Disc Lock function is in use.
The disc is upside down.
The CD is dirty or scratched.
•You are using a protected MD.
•The MD is write protected.
Small tabs on the back of the cassette are removed.
• Remove the obstruction. |
• Replace the batteries. (See page 8.) |
• Signals cannot reach the remote |
sensor. Move closer to the unit. |
• Reconnect the antenna correctly and |
securely. |
• Change the position and direction of |
the AM loop antenna. |
• Extend FM antenna and orient to the |
best reception position. |
• Plug in the AC power cord. |
• Cancel the Disc Lock function. (See |
page 19.) |
Put the disc in with the label side up.
Clean or replace the CD. (See page 59.)
•Change it with a recordable MD.
•Unprotect the MD. (See page 28.)
Cover the holes with adhesive tape.
63
