INSTALLATION
Step Nine – Turn On the AVR 146
Two steps are required the first time you turn on the AVR 146.
1.Gently press the Master Power Switch until the word OFF is no longer visible. The Power Indicator above the two power switches should light up in amber, indicating that the AVR is in Standby mode and is ready to be turned on. See Figure 34. Normally, you may leave the Master Power Switch in the ON position, even when the receiver is not being used.
Figure 34 – Power Switches
2.There are several ways in which the AVR 146 may be turned on from Standby mode.
a)Press the Standby/On Switch on the front panel. See Figure 34.
b)Press the Source Select Button on the front panel. See Figure 35.
Figure 35 – Source Select Button
c)Using the remote, press any one of these buttons: AVR, DVD/CD, TAPE/The Bridge, HDMI 1/HDMI 2, VID1, VID2, VID3, AM/FM or 6CH. See Figure 36.
Figure 36 – AVR and Input Selectors
NOTE: Any time you press one of the Input Selectors on
the remote (i.e., DVD/CD, TAPE/The Bridge, HDMI 1/HDMI 2, VID1, VID2 or VID3), the remote will switch modes so that it will only transmit the codes programmed to operate that device. In order to control the receiver, you will need to press the AVR button to return the remote to AVR mode.
26
