Example 2: In this example, your multichannel disc player is equipped with an HDMI output. Connect it as follows:
a)Connect the player’s coaxial digital audio output to the Coaxial 2 input on the AVR. This input is assigned by default to the HDMI 1 source.
b)Connect the player’s HDMI output to the HDMI 1 source input, and make sure to connect the AVR’s HDMI Output to your video display.
c)Connect the player’s
d)Program the player’s remote control codes into the HDMI 1 Input Selector.
When you wish to view a DVD, simply select the HDMI 1 source.
When you wish to play a multichannel disc, first select the HDMI 1 source to obtain the correct video signal, then select the
To select the
Figure 61 –
NOTE: The
Using the Tuner
The AVR 146’s
1.Press the Source Selector Button on the front panel repeatedly until the tuner is selected. The
2.Press the Tuner Band Button (marked AM/FM). Press this button again to switch bands.
3.Press the Tuner Input Selector (marked AM/FM) on the remote. Press this button again to switch bands.
OPERATION
Figure 62 – Tuner Input Selection
Radio stations may be selected in one of four ways (see Figure 63):
1.If you know the frequency number, enter it directly by first pressing the Direct Button on the remote, and then using the Numeric Keys.
2.After you have programmed Preset stations (see below), either enter the Preset number (1 through 30) using the remote or use the Preset Stations Button
3.In Auto tuning mode, with each press of the Tuning Buttons (front- panel or remote) the AVR 146 will scan in the chosen direction until a station with acceptable signal strength is detected. Press the Tuning Button again to stop scanning.
4.In Manual tuning mode, with each press of the Tuning Buttons the AVR 146 will tune the next frequency increment (0.1MHz for FM, or 10kHz for AM) in the selected direction. Press and hold the Tuning Button for faster scanning.
Figure 63 – Tuning a Station
Press the Tuning Mode Button
Figure 64 – Tuning Mode
To store a station in one of the 30 presets (see Figure 65):
1.Tune the desired station.
2.Press the Memory Button on the remote.
3.Use the Numeric Keys to enter the desired preset number.
Figure 65 – Storing a Preset Station
37