Hitachi CP-X200 instruction manual Using the Keypad Devices, Key and Indicator Legend

3－3

33

Using the Keypad Devices

The X200 Series inverter front keypad contains all the elements for both monitoring and programming parameters. The keypad is layout is pictured below. All other programming devices for the inverter have a similar key arrangement and function.

Display Units (Hertz / Amperes) LEDs

Parameter Display

Run key Enable LED Run key

Stop/Reset key

Function key

				Power LED
		Hz	POWER	Alarm LED
				Run/Stop LED
		A	ALARM
	STOP	RUN		Potentiometer Enable LED
RUN
	RESET	PRG
				Potentiometer
FUNC	1	2	STR	Program/Monitor LED
Up/Down keys			Store key

Configuring

Key and Indicator Legend

ξRun/Stop LED – ON when the inverter output is ON and the motor is developing torque (Run Mode), and OFF when the inverter output is OFF (Stop Mode).

ξProgram/Monitor LED – This LED is ON when the inverter is ready for parameter editing (Program Mode). It is OFF when the parameter display is monitoring data (Monitor Mode).

ξRun Key Enable LED – is ON when the inverter is ready to respond to the Run key, OFF when the Run key is disabled.

ξRun Key – Press this key to run the motor (the Run Enable LED must be ON first). Parameter F004, Keypad Run Key Routing, determines whether the Run key generates a Run FWD or Run REV command.

ξStop/Reset Key – Press this key to stop the motor when it is running (uses the programmed deceleration rate). This key will also reset an alarm that has tripped.

ξPotentiometer – Allows an operator to directly set the motor speed when the potentiometer is enabled for output frequency control.

ξPotentiometer Enable LED – ON when the potentiometer is enabled for value entry.

ξParameter Display – A 4-digit, 7-segment display for parameters and function codes.

ξDisplay Units, Hertz/Amperes – One of these LEDs will be ON to indicate the units associated with the parameter display.

ξPower LED – This is ON when the power input to the inverter is ON.

ξAlarm LED – ON when an inverter trip is active (alarm relay contact will be closed).

ξFunction Key – This key is used to navigate through the lists of parameters and functions for setting and monitoring parameter values.

ξUp/Down keys – Use these keys alternatively to move up or down the lists of parameter and functions shown in the display, and increment/decrement values.

ξStore key – When the unit is in Program Mode and you have edited a parameter value, press the Store key to write the new value to the EEPROM.

Parameters	Drive
Parameters	&RQ¿JXULQJ'ULYH