Hitachi CP-X200 instruction manual Reduces output as needed

6－4

64

Troubleshooting and	Troubleshooting and	Maintenance
	Maintenance

Symptom/condition		Probable Cause	Solution
		ξ If using the analog input, is the	ξ Check the wiring.
		current or voltage at [O] or [OI]?	ξ Check the potentiometer or
			signal generating device.
The motor speed will not		ξ Is the load too heavy?	ξ Reduce the load.
			ξ Heavy loads activate the
reach the target frequency			overload restriction feature
(desired speed).			(reduces output as needed).
		ξ Is the inverter internally limiting	ξ Check max frequency setting
		the output frequency?	(A004)
			ξ Check frequency upper limit
			setting (A061)
		ξ Is the load fluctuation too great?	ξ Increase the motor capacity
		ξ Is the supply voltage unstable?	(both inverter and motor).
The rotation is unstable		ξ Is the problem occurring at a	ξ Fix power supply problem.
		particular frequency?	ξ Change the output frequency
			slightly, or use the jump
			frequency setting to skip the
			problem frequency.
		ξ Is the maximum frequency setting	ξ Verify the V/f settings match
The RPM of the motor does		A004 correct?	motor specifications.
not match the inverter		ξ Does the monitor function D001	ξ Make sure all scaling (such as
output frequency setting.		display the expected output	A011 to A014) is properly set.
		frequency?
		ξ Was power turned OFF after a	ξ Edit the data and press the
		parameter edit but before pressing	Store key once.
	No download has	the Store key?	ξ Wait six seconds or more
Inverter	occurred	ξ Edits to data are permanently
		stored at power down. Was the time	before turning power OFF
data us not		from power OFF to power ON less	after editing data.
correct	The download	than six seconds?
		ξ Was the power turned OFF within	ξ Copy the data to the inverter
	to the inverter	six seconds after the display	again, and keep power ON for
	was attempted	changed from REMT to INV?	six seconds or more after
A			copying.
	True for	ξ Is the inverter in Run Mode? Some	ξ Put inverter in Stop Mode
parameter		parameters cannot be edited during	(press the Stop/reset key).
will not	certain	Run Mode.	Then edit the parameter.
change	parameters
after an	True for all	ξ If you’re using the [SFT] intelligent	ξ Change the state of the SFT
edit
(reverts to	parameters	input (software lock function)—is	input, and check the B031
old		the [SFT] input ON?	parameter (SFT mode).
setting).