Hitachi CP-X200 instruction manual Appendix BAppendix B

B－7

B7

Data:

ξA function command is set here.

ξThe data format used in the X200 series is corresponding to the Modbus data format below.

Name of Data	Description
Coil	Binary data that can be referenced and changed ( 1 bit long)
Holding Register	16-bit data that can be referenced and changed

Function code:

Specify a function you want to make the inverter execute. Function codes available to the X200 series are listed below.

		Maximum data size	Maximum number of
Function Code	Function	(bytes available	data elements available
		per message)	per message
0 1 h	Read Coil Status	4	32 coils (in bits)
0 3 h	Read Holding Resistor	4	4 registers (in bytes)
0 5 h	Write in Coil	1	1 coil (in bits)
0 6 h	Write in Holding Register	1	1 register (in bytes)
0 8 h	Loopback Test		
0 F h	Write in Coils	4	32 coils (in bits)
1 0 h	Write in Registers	4	4 registers (in bytes)

Appendix BAppendix B

Error check:

Modbus-RTU uses CRC (Cyclic Redundancy Check) for error checking.

ξThe CRC code is 16-bit data that is generated for 8-bit blocks of arbitrary length.

ξThe CRC code is generated by a generator polynomial CRC-16 (X16+ X15+ X2+ 1).

Header and trailer (silent interval):

Latency is the time between the reception of a query from the master and transmission of a response from the inverter.

ξ3.5 characters (24 bits) are always required for latency time. If the latency time shorter than 3.5 characters, the inverter returns no response.

ξThe actual transmission latency time is the sum of silent interval (3.5 characters long) + C078 (transmission latency time).