Hitachi CP-X200 instruction manual －54, 54, Output Terminal Configuration, Out-Tm Ry, Am-Kind

3－54

354

Output Terminal Configuration

The inverter provides configuration for logic (discrete) and analog outputs, shown in the table below.

“C” Function

Run

Defaults

Func.

Name /

Description

Mode -FE -FU

Units

Code

SRW Display

Edit

(EU)

(USA)

C021

Terminal [11] function

12 programmable functions available

01

01



OUT-TM 11

FA1

for logic (discrete) outputs

[FA1]

[FA1]

(see next section)

C026

Alarm relay terminal

12 programmable functions available

05

05



function

AL

for logic (discrete) outputs

[AL]

[AL]

OUT-TM RY

(see next section)

C028

AM signal selection

Two available functions:

00

00

00

motor speed

[freq]

[freq]

&RQ¿JXULQJ'ULYH Parameters

AM-KIND

01

motor current

Run

Defaults

Parameters

ConfiguringDrive

“C” Function

F

(see after next section)

The output logic conversion is programmable for terminal [11] and the alarm relay

terminal. The open-collector output terminal [11] defaults to normally open (active low),

but you can select normally closed (active high) for the terminal in order to invert the

sense of the logic. You can invert the logical sense of the alarm relay output as well.

Func.

Name /

Description

Mode -FE -FU

Units

Code

SRW Display

Edit

(EU)

(USA)

C031	Terminal [11] active		Select logic conversion, two option		00	00	
	state		codes:
			00	normally open [NO]
			01	normally closed [NC]
	O/C-11	NO
C036	Alarm relay active state		Select logic conversion, two option		01	01	
			codes:
			00	normally open [NO]
	O/C-RY	NC	01	normally closed [NC]