Hitachi CP-X200 instruction manual －29, Force Operation from Digital Operator

4－29

429

Force Operation from Digital Operator

This function permits a digital operator interface to override the following two settings in the inverter:

ξA001 - Frequency source setting

ξA002 - Run command source setting

When using the [OPE] terminal input, typically A001 and A002 are configured for sources other than the digital operator interface for the output frequency and Run command sources, respectively. When the [OPE] input is ON, then user has immediate command of the inverter, to start or stop the motor and to set the speed.

Option	Terminal	Function Name	State	Description
Code	Symbol
31	OPE	Force Operation	ON	Forces the operator interface to override:
		from Digital		A001 - Frequency Source Setting, and A002 - Run
		Operator		Command Source Setting
			OFF	Parameters A001 and A002 are in effect again,
				for the frequency source and the Run command
				source, respectively

Valid for inputs:	C001~C005
Required settings	A001 (set not equal to 00)
	A002 (set not equal to 02)

Notes:

ξWhen changing the [OPE] state during Run Mode (inverter is driving the motor), the inverter will stop the motor before the new [OPE] state takes effect.

ξIf the [OPE] input turns ON and the digital operator gives a Run command while the inverter is already running, the inverter stops the motor. Then the digital operator can control the motor.

Example (default input configuration shown—see page 3–49):

		OPE
5	4	3	2	1	L	PCS	P24

See I/O specs on page 4–6.

Monitoring	Operationsand
Monitoring	Operationsand