Hitachi CP-X200 instruction manual －59

Configuring Drive Parameters

								3－59
								
								3 59
		“C” Function		Run		Defaults
Func.	Name /		Description	Mode -FE -FU				Units
Code	SRW Display			Edit (EU)			(USA)
C041	Overload level setting		Sets the overload signal level		Rated current			A
			between 0% and 200% (from 0 to		for each
			two time the rated current of the		inverter model
	OV LVL	001.60A	inverter)
C241	Overload level setting,		Sets the overload signal level		Rated current			A
	2nd motor		between 0% and 200% (from 0 to		for each
			two time the rated current of the		inverter model
	2OV LVL	001.60A	inverter)
C042	Frequency arrival setting		Sets the frequency arrival setting		0.0		0.0	Hz
	for acceleration		threshold for the output frequency
			during acceleration,
	ARV ACC	0000.0Hz	range is 0.0 to 400.0 Hz
C043	Frequency arrival setting		Sets the frequency arrival setting		0.0		0.0	Hz
	for deceleration		threshold for the output frequency
			during deceleration,
	ARV DEC	0000.0Hz	range is 0.0 to 400.0 Hz
C044	PID deviation level setting		Sets the allowable PID loop error		3.0		3.0	%	&RQ¿JXULQJ'ULYH Parameters
	PID LtU	0100.0%	100%
			magnitude (absolute value), SP-PV,
	ARV PID	003.0%	range is 0.0 to 100%
C052	PID FBV function high		When the PV exceeds this value,		100.0		100.0	%
	limit		the PID loop turns OFF the PID
			second stage output, range is 0.0 to
C053	PID FBV function variable		When the PV goes below this		0.0		0.0	%
	low limit		value, the PID loop turns ON the
			PID second stage output, range is
	PID LtL	0000.0%	0.0 to 100%