Hitachi CP-X200 instruction manual CE-EMC Installation Guidelines

D－2

D2

CE-EMC Installation Guidelines

	D
$SSHQGL['	Appendix

You are required to satisfy the EMC directive (89/336/EEC) when using an X200 inverter in an EU country. To satisfy the EMC directive and to comply with standard, follow the guidelines in this section.

1.As user you must ensure that the HF (high frequency) impedance between adjustable frequency inverter, filter, and ground is as small as possible.

ξEnsure that the connections are metallic and have the largest possible contact areas (zinc-plated mounting plates).

2.Avoid conductor loops that act like antennas, especially loops that encompass large areas.

ξAvoid unnecessary conductor loops.

ξAvoid parallel arrangement of low-level signal wiring and power-carrying or noise-prone conductors.

3.Use shielded wiring for the motor cable and all analog and digital control lines.

ξAllow the effective shield area of these lines to remain as large as possible; i.e., do not strip away the shield (screen) further away from the cable end than absolutely necessary.

ξWith integrated systems (for example, when the adjustable frequency inverter is communicating with some type of supervisory controller or host computer in the same control cabinet and they are connected at the same ground + PE-potential), connect the shields of the control lines to ground + PE (protective earth) at both ends. With distributed systems (for example the communicating supervisory controller or host computer is not in the same control cabinet and there is a distance between the systems), we recommend connecting the shield of the control lines only at the end connecting to the adjustable frequency inverter. If possible, route the other end of the control lines directly to the cable entry section of the supervisory controller or host computer. The shield conductor of the motor cables always must connected to ground + PE at both ends.

ξTo achieve a large area contact between shield and ground + PE-potential, use a PG screw with a metallic shell, or use a metallic mounting clip.

ξUse only cable with braided, tinned copper mesh shield (type “CY”) with 85% coverage.

ξThe shielding continuity should not be broken at any point in the cable. If the use of reactors, contactors, terminals, or safety switches in the motor output is necessary, the unshielded section should be kept as short as possible.

ξSome motors have a rubber gasket between terminal box and motor housing. Very often, the terminal boxes, and particularly the threads for the metal PG screw connections, are painted. Make sure there is always a good metallic connection between the shielding of the motor cable, the metal PG screw connection, the terminal box, and the motor housing. If necessary, carefully remove paint between conducting surfaces.