Hitachi CP-X200 instruction manual Restoring Factory Default Settings, B085

6－8

68

Troubleshooting and	Troubleshooting and	Maintenance
	Maintenance

Restoring Factory Default Settings

You can restore all inverter parameters to the original factory (default) settings for the intended country of use. After initializing the inverter, use the powerup test in Chapter 2 to get the motor running again. To initialize the inverter, follow the steps below.

No.			Action		Display	Func./Parameter
1	Use the FUNC ,		1 , and	2 keys to	b---	“B” Group selected
	navigate to the “B” Group.
2	Press the	FUNC	key.		b001	First “B” parameter selected.
3	Press and hold the 1			key until Æ	b085	Country code for initialization
						selected
4	Press the	FUNC	key.		02	00=Japan, 01=Europe
						02=USA

5Confirm the country code is correct. Do not change it unless you are absolutely sure the power input voltage range and frequency matches the country code setting.

	To change the country code, press 1			or 2 to set, STR to store.
6	Press the	FUNC	key.	b085	Country code for initialization
					selected
7	Press the	2	key.	b084	Initialization function selected
8	Press the	FUNC	key.	00	00=initialization disabled, clear
					trip history only
9	Press the	1	key.	01	01=initialization enabled
10	Press the	STR	key.	b084	Initialization now enable to
					restore all defaults
11	Press and hold the FUNC , 2 and			b084	First part of special key sequence
	STOP keys. Do not release yet.
	RESET
12 When your country code appears in				EU	Default parameter country code
	the display, release all the keys.			USA	shown during initialization
					process (left-most char displays
				JP	alternating pattern)
13	Initialization is complete			d001	Function code for output
					frequency monitor shown

NOTE: Initialization cannot be performed with a remote operator panel. Disconnect the dovice and use the inverter’s front keypad.