Hitachi CP-X200 instruction manual －51, 51

Configuring Drive Parameters

3－51

351

Input Function Summary Table – This table shows all thirty-one intelligent input functions at a glance. Detailed description of these functions, related parameters and settings, and example wiring diagrams are in “Using Intelligent Input Terminals” on page 4-8.

Input Function Summary Table

Option	Terminal	Function Name		Description
Code	Symbol
00	FW	FORWARD Run/Stop	ON	Inverter is in Run Mode, motor runs forward

			OFF	Inverter is in Stop Mode, motor stops
01	RV	Reverse Run/Stop	ON	Inverter is in Run Mode, motor runs reverse
			OFF	Inverter is in Stop Mode, motor stops
02	CF1 *1	Multi-speed Select,	ON	Binary encoded speed select, Bit 0, logical 1
		Bit 0 (LSB)	OFF	Binary encoded speed select, Bit 0, logical 0
03	CF2	Multi-speed Select,	ON	Binary encoded speed select, Bit 1, logical 1
		Bit 1	OFF	Binary encoded speed select, Bit 1, logical 0
04	CF3	Multi-speed Select,	ON	Binary encoded speed select, Bit 2, logical 1
		Bit 2	OFF	Binary encoded speed select, Bit 2, logical 0
05	CF4	Multi-speed Select,	ON	Binary encoded speed select, Bit 3, logical 1
		Bit 3 (MSB)	OFF	Binary encoded speed select, Bit 3, logical 0	&RQ¿JXULQJ'ULYH Parameters
06	JG	jogging	ON	Inverter is in Run Mode, output to motor runs
				at jog parameter frequency
			OFF	Inverter is in Stop Mode
07	DB	External DC braking	ON	DC braking will be applied during deceleration
			OFF	DC braking will not be applied
08	SET	Set (select) 2nd Motor	ON	The inverter uses 2nd motor parameters for
		Data		generating frequency output to motor
			OFF	The inverter uses 1st (main) motor parameters
				for generating frequency output to motor
09	2CH	2-stage Acceleration	ON	Frequency output uses 2nd-stage acceleration
		and Deceleration		and deceleration values
			OFF	Frequency output uses standard acceleration
				and deceleration values
11	FRS	Free-run Stop	ON	Causes output to turn OFF, allowing motor to
				free run (coast) to stop
			OFF	Output operates normally, so controlled
				deceleration stop motor
12	EXT	External Trip	ON	When assigned input transitions OFF to ON,
				inverter latches trip event and displays E12
			OFF	No trip event for ON to OFF, any recorded trip
				events remain in history until reset
13	USP	Unattended Start	ON	On powerup, the inverter will not resume a Run
		Protection		command (mostly used in the US)
			OFF	On powerup, the inverter will resume a Run
				command that was active before power loss
15	SFT	Software Lock	ON	The keypad and remote programming devices
				are prevented from changing parameters
			OFF	The parameters may be edited and stored
16	AT	Analog Input	ON	Refer to “Analog Input Settings” on page 3-13.
		Voltage/Current Select	OFF
18	RS	Reset Inverter	ON	The trip condition is reset, the motor output is
				turned OFF, and powerup reset is asserted
			OFF	Normal power-ON operation