Hitachi CP-X200 instruction manual －52, Anlg

3－52
3		52
		Option	Terminal	Input Function Summary Table
				Function Name		Description
		Code	Symbol
		19	PTC	PTC thermistor	ANLG	When a thermistor is connected to terminal [5]
				Thermal Protection		and [L], the inverter checks for over-temperature
						and will cause trip event and turn OFF output to
						motor
					OPEN	A disconnect of the thermistor causes a trip
						event, and the inverter turns OFF the motor
		20	STA	Start	ON	Starts the motor rotation
				(3-wire interface)	OFF	No change to present motor status
		21	STP	Stop	ON	Stops the motor rotation
				(3-wire interface)	OFF	No change to present motor status
		22	F/R	FWD, REV	ON	Selects the direction of motor rotation: ON =
				(3-wire interface)		FWD. While the motor is rotating, a change of
						F/R will start a deceleration, followed by a
						change in direction
					OFF	Selects the direction of motor rotation: OFF =
						REV. While the motor is rotating, a change of F/R
&RQ¿JXULQJ'ULYH Parameters						will start a deceleration, followed by a change in
						direction
		23	PID	PID Disable	ON	Temporarily disables PID loop control. Inverter
						output turns OFF as long as PID Enable is active
						(A071=01)
					OFF	Has no effect on PID loop operation, which
						operates normally if PID Enable is active
						(A071=01)
		24	PIDC	PID Reset	ON	Resets the PID loop controller. The main
						consequence is that the integrator sum is forced
						to zero
					OFF	No effect on PID controller
		27	UP	Remote Control UP	ON	Accelerates (increases output frequency) motor
				Function (motorized		from current frequency
				speed pot.)	OFF	Output to motor operates normally
		28	DWN	Remote Control Down	ON	Decelerates (decreases output frequency) motor
				Function (motorized		from current frequency
				speed pot.)	OFF	Output to motor operates normally
		29	UDC	Remote Control Data	ON	Clears the UP/DWN frequency memory by
				Clearing		forcing it to equal the set frequency parameter
						F001. Setting C101 must be set=00 to enable this
						function to work
					OFF	UP/DWN frequency memory is not changed
		31	OPE	Operator Control	ON	Forces the source of the output frequency setting
						A001 and the source of the Run command A002
						to be from the digital operator
					OFF	Source of output frequency set by A001 and
						source of Run command set by A002 is used

Parameters Configuring Drive