Installation and Connections
External Audio Power Amplifier
Connections
If desired, the AVR 7000 may be connected to optional, external audio power amplifiers or used with equalizers or speaker systems that require connection between the preamp and amplifier sections of a receiver.
To make these connections, remove the jumpers that connect the Preamp Out jacks ß and Amplifier In jacks Ú for the channels to be used with external devices. Store the jumpers in a safe place so that the AVR may be used in its normal mode at a future date, if desired.
When an external amplifier is used, connect the Preamp Out jacks ß to the inputs on the amplifier. When an equalizer or speaker proces- sor is used, connect the Preamp Out jacks ß to the inputs of the processor, and connect the outputs of the processor back to the Amplifier In jacks Ú on the AVR. Note that when exter- nal amplifiers or devices are used, the volume control is still controlled by the AVR, although additional volume controls on the external device may impact the volume settings and out- put levels from the AVR.
External Audio Decoder Connection
To provide for ultimate flexibility, the AVR 7000 may be used in conjunction with optional, external decoders for digital audio systems other than the AVR 7000’s own
These jacks may also be used for connections to devices such as DVD players or High Definition Television (HDTV) sets or decoders that feature
AC Power Connections
This unit is equipped with three accessory AC outlets. They may be used to power accessory devices, but they should not be used with high- current draw equipment such as power ampli- fiers. The total power draw to each outlet may not exceed 100 watts.
The Switched Ü outlets will receive power only when the unit is on. This is recommended for devices that have no power switch or a mechanical power switch that may be left in the “ON” position.
NOTE: Many audio and video products go into a Standby mode when they are used with switched outlets, and cannot be fully turned on using the outlet alone without a remote control command.
The Unswitched Û outlet will receive power as long as the unit is plugged into a powered AC outlet.
Finally, when all connections are complete, plug the power cord into a nonswitched
17INSTALLATION AND CONNECTIONS