Harman-Kardon Car Stereo System owner manual Operating Drive + Play, Distraction Warning, Overview

Installing Components

Installing the Control Knob (continued)

2.At the base (below the cable), using the 1.5mm hex key, loosen (but do not remove) the hex setscrew.

3.To install the Control Knob with adhesive tape, perform the following steps or skip to step 4:

a.Insert the mounting plate, rotate it 180°, and tighten the hex setscrew.

Control Knob

With 0° Base

Mounting

Plate

Adhesive

Pad

b. At the site, wipe the surface and exposed mounting
	plate with one of the enclosed alcohol pads. Allow both
	to dry.
c.	Remove the protective tape from one side of one of the
	enclosed adhesive pads, and press the pad against the
	mounting plate.
d. Remove the remaining protective tape, and press and
	hold the Control Knob to its site for 5 seconds.
4. To install the Control Knob with mounting screws, perform
the following steps:
a. At the proposed site, place the mounting plate and
	rotate it so that the arrow will point toward the hex

Control Knob

With 0° Base

Arrow

Mounting

Plate

5. Route the attached cable to the Electronics Enclosure.

Installing the iPod Cable

Route the iPod dock connector cable to the chosen iPod site (e.g., the center console compartment or the glove box). Be sure to leave enough cable exposed to make connecting and disconnecting the iPod easy.

Making the System Connections

With all power off, refer to the Wiring Diagram on page 5 and make only the power, ground and audio signal connections that apply to the scheme you have chosen. After verifying all connections including the iPod, proceed to the next section, Operating Drive + Play.

OPERATING DRIVE + PLAY

Distraction Warning

Do not connect or disconnect your iPod or program Drive + Play while driving. Always pull off the road and park in a position that you are absolutely sure presents no risk before browsing your iPod or adjusting the settings on your Drive + Play. Always obey all traffic laws while driving.

set-screw at the back of the base after it’s mounted.

b. Holding the mounting plate in position, fasten it to the

surface with three enclosed mounting screws.

c. Using the mounting plate’s center hole as a template,

drill a hole through the mounting surface and pass the

Overview

	Menu
	Press Once to
Scroll Ring	Jump to Last Screen
Scroll Left Once to Last Menu Item
Scroll Left and Hold to Jump Back
In Now Playing, Scroll Left to
Fast Rewind

Scroll Ring

Scroll Right Once to Next Menu Item Scroll Right and Hold to Jump Forward

In Now Playing, Scroll Right to Fast Forward

Control Knob’s cable through the hole.

d. Place the Control Knob on the mounting plate (180°

from its final position), and then rotate it a half-turn to

Previous/Rewind	Next/Fast Forward
Press Once to Play Last Track	Press Once to Play Next Track

the final position. Tighten the hex setscrew at the back

of the base.

Play/Pause

Select

Press Once to Choose Highlighted Menu Item

Press Once to Stop or

Resume Play of Current Track

8 INSTALLATION/OPERATION