Dpr | Harman-Kardon Car Stereo System, 376, DPR 2005 instruction

®

®

Power for the Digital Revolution.

DPR 2005

DIGITAL PATH RECEIVER

OWNER’S MANUAL

Image 1

Harman-Kardon Car Stereo System, 376, DPR 2005 owner manual Dpr, Digital Path Receiver

Contents

Digital Path Receiver DPR See trademark acknowledgements on DPR 2005 Digital Path Receiver Introduction Description and FeaturesThank You for Choosing Harman Kardon Modèle pour les Canadien Important Safety Information Safety Information Surround Mode Indicators To choose from the various mode optionsStandby/On Indicator This indicator is amber Modes, and then press the Surround Mode Selector Frequency and preset number, if any AB C D E F G H I J I K REAR-PANEL Connections ‚ CD Audio Inputs Connect these jacks to REAR-PANEL Connections Volume Up/Down Buttons Main Remote Control FunctionsProgram Button SPL Select Button EzSet Microphone Sensor Lens Have been pressed Channel Up/Down Selector . To raise Speaker Select Button Press this button Main Remote Control Functions Zone II Remote Control Functions System Installation Installation and Connections System and Power Connections AC Power Connections BUSInstallation ConnectionsRS-232 Connections Speaker Placement System ConfigurationSystem Setup Speaker Selection and Placement Making Configuration Adjustments Input SetupSetting the System Configuration Memory For DVD and the Optical Digital Input 1 ‡ › Navigation Button o Surround Setup Audio SetupFor added resolution Speaker Optimizer To return to the Master Menu DTS-ES Discrete. Press the ‹/› Navigation Button Speaker Setup Set the unit for either 5.1 or 6.1/7.1 operation To bring up the Master MENU, press Delay SettingsMeasurement units is made, press the ⁄/¤ Using EzSet Output Level AdjustmentNavigation Button o to return the cursor to the FL position Using the EzSet remote Manual Output Level AdjustmentMENU, press the OSD Button to bring up Play shown in Figure To return to normal operation of the DPR Additional Input Adjustments Operation Volume and Tone ControlBasic Operation Source Selection Dolby Mode Select Button or Surround Mode SelectionDigital Audio Playback Digital DTS Neo6 Surround Mode Chart PCM Playback Selecting a Digital SourceHdcd Playback Night Mode Speaker/Channel IndicatorsMP3 Audio Playback Tape Recording Tuner OperationFront-Panel Connections Memory Backup Output Level Trim AdjustmentMenu system Dim Function Ments to make, press the OSD Button Menu system Turn-On Volume Level Advanced FeaturesMenu system Semi-OSD Settings Button is pressed is shown Menu system Multiroom Operation Multiroom Setup Buttons ç∂d Multiroom OperationSpecific source Output Programming Remote Codes Configuring the RemoteRemote’s Main Menu message Bottom line Learning CommandsBe used Input Selector Button d that was just Changing Devices Commands from another device’s remote into the DPR remote Remember that when you want to change devices Macro. The choices are the Power On ButtonMacro Programming Lower line of the display and then press the Set Button q Programmed e.g., the Power On Button 1 or Power On VID 2/TV VID 3/Cable DPR Logic 7 hErasing a Macro Read a Macro Volume Punch-Through Punch-Through ConfigurationChannel Punch-Through When the red light under the Set Button q appears EzSet Configuration Pages 27 RenamingRenaming a Device Numeric Keys Renaming Individual Keys Resetting the RemoteAt this point you have two options Additional Notes on Configuring and Operating the Remote Processor Reset Troubleshooting Guide DPR 2005 Technical Specifications