Harman-Kardon HA160-0004-A manual Memorized

Signature 2.0

Although the basic functions of the Signature 2.0 may be operated from the front panel, most operation will be controlled through the wireless remote. The remote is a powerful tool, and it is worth taking a few minutes to familiarize yourself with the interaction of the various controls. In addition to the functions listed below, the 2.0’s remote may be programmed to operate most infrared controlled products on the market. For complete information on how to program the remote, read pages 17-18.

aMain Power On/Off: Press these buttons to turn the 2.0 on or to place it in the standby mode.

NOTE: The Master Power Switch 1 must be in the “ON” position for these, or any other buttons on the remote to operate any function on the 2.0.

bLearn LED: This indicator will illuminate when a button on the remote is being programmed with signals from another remote during the “learning” mode. The light will go out when the signal is received

and memorized.

cIR Transmitters: Behind this translucent panel are the infrared transmitters that send signals from the remote unit to the 2.0. When pressing buttons to issue commands, point this area towards the 2.0.

dSending LED: This indicator should flash any time a button is pressed to confirm that a command is being sent to the receiver of another unit. If the light is dim or does not illuminate when a button is pressed the batteries in the remote should be replaced.

eUse/Learn Switch: This switch selects the operation mode of the remote control. Slide it to the left for normal operation. Slide it to the right when the remote is being programmed.

fSource Power On/Off: Pressing these buttons will send a turn-on, turn-off command to the source device last accessed by pressing one of the Source Selection buttons g. Note that these commands may require programming of the remote control as explained on pages 17-18.

g Source Selection: Pressing these buttons will select the input source for the 2.0. It will also activate the transport and numeric control buttons associated with that device, enabling control of the source with the

2.0remote. If the 2.0 is in the Standby mode when one of these buttons is pressed, the unit will automatically turn on and switch to the selected input.

hSimulcast Button: Using this button enables you to listen to one source while you watch the video from another. To use the Simulcast feature, first press the Source Selection button g for the desired video source, followed immediately by pressing this button. Release the Simulcast button, and press the desired audio source within 5 seconds.

iMenu Control Buttons: These buttons control the location of the on-screen cursor to select items from on-screen menus, and they also act to select, move, increase or decrease items from control functions. The Ý button is often used to move from a main menu to a sub-menu, the Ü and Ý buttons are used to select choices within menus, and the Úand Û buttons are used to move up and down through lists of selections.

jMenu Button: This button is used to activate the On-Screen Menu Control System when it is not being used, or to enter selections and exit from the control system when it is active.

kTreble Cut: Press this button to activate the Treble Cut feature. When the button is pressed a menu will appear on the screen (see figure OSD-19 on page 42), and you may reduce the high-frequency level of the output by pressing the Ü or Ý Menu Control buttons i. When you have completed the adjustment, press this button again to enter the setting and remove the menu from the screen.

lSubwoofer Trim: Press this button to activate the Subwoofer Trim feature. When the button is pressed a menu will appear on the screen (see figure OSD-21 on page 42) and you may adjust the subwoofer output volume by pressing the Ü or Ý Menu Control buttons i. When you have completed the adjustment, press this button again to enter the setting and remove the menu from the screen.

Remote Control Operation

13