Harman Stove Company 2 manual Maintenance - Cleaning Glass on View Door

Maintenance - Cleaning Glass on View Door 19

The unit should be out and cool to clean the door glass. It may not always be possible to allow the unit to cool off before cleaning. Therefore, if the unit is turned to the lowest setting about 1 hour before cleaning, it will make it possible to clean the glass with the unit in operation.

Any glass cleaner with a high amonia content will work the best. Use only non-synthetic cleaning rags such as cotton or paper towels.

CAUTION: Take care when spraying cleaner on the side surface of the glass. The glass may be hot enough to cause undesirable fumes to fill the area around the unit very rapidly. Gloves and eye protection are recommended.

Inspect the hopper lid sponge gasket. It is important to maintain a good hopper lid seal.

Control door finger

hole

Do not allow pellets or sawdust to remain on the hopper lip after filling.

Glass Gasket

Replace glass only with high t e m p e r a t u r e ceramic glass.

Inspect door gasket during cleaning and inspection

HI-LO Distribution blower speed

range switch

Draft Meter hex plug

Fig. 34