does not work on all systems.
If this setting does not help, or if you experience WinTV not responding after a
channel change, then your graphics system cannot use hardware graphics accel-
eration. In this case go back to settings and uncheck “use hardware acceleration”
and rerun WinTV.
Only some channels are found during ATSC channel scan
If you are only receiving some known TV channels when scanning, it means your
TV antenna is not adequate to pick up the channel. You will need either an anten-
na signal booster (a Radio Shack antenna amplifier will work) or a high gain
antenna. Here’s a link to an ATSC antenna selector:
http://www.antennaweb.org/aw/address.aspx
Black window when selecting an ATSC channel
If analog channels are displayed correctly but you see a black window when
selecting an ATSC channels, this means that WinTV is not getting a signal. This is
most often due to poor reception. See “Only some channels are found during
ATSC channel scan” above.
page 13