1.25 1.25
Ignition Switch
The engine may only be started when the ignition
switch is in the ‘on’ position (B).
WARNING: PREVENT ACCIDENTS - Always
switch the ignition key to the ‘off’ position (A)
and remove the key when the mower is not in
use.
Cutterhead Drive Operation
The cutterhead drive engagement mechanism is
protected by the Operator Presence Control (OPC)
system.
To engage cutterhead drive: Push the cutterhead
clutch control lever forwards with the left hand
while pushing downwards on the OPC lever with
the palm of the right hand, release the cutterhead
clutch control lever and the cutterhead drive will
remain engaged until such time as the OPC levers
are released. The OPC levers are duplicated on
each handlebar and operation of either (or both)
will keep the system activated.
To disengage cutterhead drive: Release the OPC
levers. Observe that the cutterhead clutch control
lever automatically returns backwards to the disen-
gaged position.
WARNING: PREVENT ACCIDENTS - Do not
operate the mower if the handlebar controls of
the operator presence control system are defec-
tive in any way. ALWAYS replace faulty parts
and check that they function correctly before
operating the mower.
Starting the Engine
This machine is fitted with an Engine Start
Lockout, refer to OPERATOR PRESENCE
CONTROL.
WARNING: PREVENT ACCIDENTS - Before
starting the engine check that:
- The area is clear of bystanders.
- The cutterhead drive is disengaged.
- The parking brake is engaged.
- The travel controls are in neutral.
- You have read and understood the Safety
Precautions Section in this manual.
OPERATING THE MOWER
2
12
STOP
A
B
STOP
A
B
Engage Cutterhead Drive
Disengage Cutterhead Drive