8.With the help of a second person, hold the Console Base (47) near the Left Handrail (71). Attach the end of the ground wire to the indicated small hole in the Left Handrail with the Silver Ground Screw (75).
9.Touch the Right Handrail (72) to discharge any static. See the inset drawing. Slide the sleeve off the connec- tor on the Upright Wire (42). Next, press the end of the Upright Wire into the socket in the bottom of the Console Base (47). The connectors should slide together eas- ily and snap into place. If they do not, turn one connec- tor and try again. IF THE CONNECTORS ARE NOT
CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Then, slide the sleeve back over the connector.
10.Set the Console Base (47) on the Handrails (71, 72). Attach the Console Base with four 3/4" Screws (2). Start all four Screws before tightening them; do not over- tighten the Screws.
See the lower drawing. Make sure that the Upright Wire (42) is routed below the two indicated round posts (A). Next, press the Upright Wire into the slot be- tween the square post (B) and the Console Base (47).
8
Ground
Wire 
47
Small
Hole 
71 |
| 75 |
|
|
|
| |
9 |
|
|
|
72 |
|
|
|
|
| 42 | 47 |
|
|
| |
| Sleeve | Connector |
|
42 |
|
|
|
10 |
| 47 |
|
|
|
| |
72 |
|
| 71 |
2 |
|
|
|
|
|
| 2 |
| A |
|
|
|
| B |
|
42 | 47 |
|
|
9
