![](/images/new-backgrounds/1319978/31997811x1.webp)
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included hex key | and your own Phillips screwdriver | , rubber mal- | |
let | , adjustable wrench | , and needlenose pliers | . |
For help identifying the assembly hardware, see the drawings below. If a part is not in the parts bag, check to see if it has been
1/2" Screw | 3/4" Screw | 1" Tek Screw | 1" Upright | |
|
|
| Bolt | |
Silver Ground |
| 5/16" Star Washer |
| |
Screw |
|
| ||
Nut | Wheel Bolt | |||
| ||||
3" Upright Bolt | Handrail Bolt |
1.Make sure that the power cord is unplugged.
With the help of a second person, carefully tip the tread- mill onto its left side as shown. Partially fold the Frame
(86)so the treadmill is more stable. Do not fully fold the treadmill until it is completely assembled.
See the inset drawing. Make sure that there are two U- Nuts (99) in the lower end of each Upright (7, 90). Identify the Right Upright (90) with the sticker. Hold the Right Upright near the right side of the Upright Base (69), with the Right Upright turned as shown. Feed the colored tie and Upright Wire (42) into the lower end of the Right Upright and out of the upper end. If necessary, use needlenose pliers to pull the tie out the upper end.
Pull on the end of the Upright Wire (42) to remove any slack as you hold the Right Upright (90) against the Upright Base (69); be careful not to pinch the Upright Wire. Start a 3" Upright Bolt (21) and a 1" Upright Bolt
(76)with 5/16" Star Washers (95) into the Upright Base and the Right Upright as shown. Do not tighten the
Bolts yet.
1 |
|
|
Tie |
|
|
90 |
|
|
42 | 69 |
|
42 |
|
|
| 95 | 21 |
|
| |
|
| 76 |
86 |
|
|
| 7, 90 |
|
|
| 99 |
6