Mountings
Fig. 3
Step 3: Tank Holder Ring Assembly For LP Gas Models (Fig. 4)
1.The L.P. Tank Holder Ring Connects to the lower shelf cross frame with the ring notches resting on the axle frame.
2.Align the rear tank
3.Fasten the thumb screw (¼- 20 x ¾") to the tank ring fitting with the ¼ - 20 Hex nuts. The Hex nut slips into the captive slot on the tank ring fitting.
4.Use a ¼ - 20 x 1½" slotted bolt and a ¼ - 20 Kep nut to connect the tank holder flanges together.
For Natural Gas Models
(Note: Tank Holder Ring is not included with natural gas models.)
If the grill is to use natural gas from the supplied 12- foot hose: the hose must pass through the hose clamp (See Fig. 1). The hose will have a quick- disconnect fitting at the source and the source will have a gas shut off valve with easy access.
When you have completed the mount assembly go to the appropriate Grill Assembly Section and assemble the grill head.
Caution: Combustible material should never be within 24 inches of the top, bottom, back or sides of your MHP Gas Barbecue Grill.
Deck/Patio Mounting
Assembly Instructions (MPB)
•Either the JNR or WNK model grills may be mounted on the Deck/Patio base.
•The gas supply may be either LP or Natural.
•The grill head bottom should not be attached to the post until the mount is fasten to a deck/patio.
Please check to be sure that all parts are included before proceeding. Contact your dealer if any parts are missing.
Parts | Quantity |
2' Post | 1 |
Patio Base | 1 |
Post Access Door | 1 |
Grease Cup Holder | 1 |
28” Stainless Steel Tubing | 1 |
Stainless Steel Grease Cup | 1 |
Hardware Kit |
|
¼ - 20 x ¾" Hex Head Bolts | 7 |
¼ - 20 Kep Nuts | 7 |
¼" Flat Washers | 7 |
8 - 32 x ½" Self Tapping Screw | 1 |
Tube Clip | 1 |
Continue on following page. !
7
