6.3.12.Assembly of Disk Cover
Assembly of Disk Cover
Installation of PAD Cover Ring | Installation of Disk Cover Shaft | |
Disc Cover |
|
|
| Pin 2 | Pin 1 |
Convex part
Latch
Disk Cover Shaft
Convex part
Arm spring for Disk Cover
Insert under
the Hook
PAD Cover Ring
Insert two Convex parts in the hole of Disc Cover. Hang two latch on Disc Cover.
Insert the Arm Spring for the Disk Cover in the Disk Cover. Insert pin 1 of the Disk Cover Shaft through the
inside diameter of the Spring.
Pin 2 of the Disk Cover Shaft must be slided, and insert in the hole of the Disk Cover.
Installation of various dampers on Disk Angle
Disk Angle Sheet B/C is pasted. | Disk Angle Sheet A is pasted. |
| |
| Disk Angle |
Disk Angle Sheet B
0 | 1mm |
Disk Angle Sheet C | 0 1mm |
Disk Angle Sheet A
01mm
Disk Angle FPC Cover is pasted. | PET Tape is pasted. |
| ||
Disk Angle FPC Cover |
|
| ||
Disk Angle |
| |||
Insert the hook in the corner hole. | 0 1mm | 0 1mm | ||
|
|
| Disk Angle |
|
0 1mm | a b | c | Cushion |
|
|
| 0 | mm |
|
Disk Angle Cushion |
| 0 1mm | PET Tape |
|
DXQT2+D25FNL |
| |||
|
| |||
(N8) |
|
|
|
|
Disk Angle Cushion
Installation of Disk Cover
Arrange Disk Cover Shaft at the left of the bend of the Disk Angle.
<Figure after | installations> |
Insertion into a slot makes | |
PIN slide. | Insert the hook in the corner hole. |
51