Matsushita CF-W4HWEZZBM service manual Specification of affixation of PET tape to Heat Spreader

3.Screw tightening of Bottom Case

1.The screw tightening is done in the undermentioned order. 3-1. DXHM0039ZA(E:N6) is tightened.No.1 to No.3

3-2. DXHM0057ZA(C:N7) is tightened. No.4,No.5

3-3. DXQT2+E12FNL(F:N11) is tightened. No.6 to No.9

3-4. DXQT2+E10FNL(D:N10) is tightened. No.10

3-5. DXQT2+D4FNL(H:N9) is tightened. No.11

3-6. DRHM0092ZA(B:N4) is tightened. No.12 to No.14

Screw (E)

Screw (B)

Screw (B)

Screw (E)

Screw (B)

Screw (C)

Screw (D)

Screw (H)

Screw (C)

Screw (F)

Screw (F)

Screw (F)

Screw (E)

Screw (F)

6.3.15.Specification of affixation of PET tape to Heat Spreader

<The Main Board Side>

Heat Radiation Grease(G-751)

Spread with a treatment device.

Heat Spreader

1~2mm

The extent that length remains pastes on an opposite side.

The extent that length remains pastes on an opposite side.

PET Tape

1~2mm

<The Back Completion Chart>

PET Tape

Never touch the aluminum edge part directly by bare-handed when the part of aluminum with a thin all surroundings bends. Correct in that case with a radio pincers etc. and instal.

54