8. Slide the Left Base Leg Cover (82) over the end of the Left Upright (111). Attach the Left Base Leg Cover with three #8 x 3/4" Screws (6) and two #8 x 2 1/4" Screws (7). Be careful not to over- tighten the Screws.
With the help of a second person, carefully tip the treadmill down so that the Base (85) is flat on the floor.
9.With the help of a second person, hold the con- sole assembly near. the Left Upright (111) and the Right Upright (113)
Connect the Upright Wire Harness (73) to the Console Wire (119). See the inset drawing.
The connectors should slide together easily and snap into place; if they do not, turn one connector and try again. IF THE CONNECTORS
ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN YOU TURN ON THE POWER. Then, insert the con- nectors and the excess wire into the Right Upright (113).
Insert the front ends of the brackets on the con- sole assembly into the Right Upright (113) and the Left Upright (111). Then, insert the rest of the brackets into the Uprights. Make sure that the
Wire Harnesses (73, 119) are not pinched.
8 | 82 |
| |
| 111 |
| 85 |
| 6 |
| 7 |
9 |
|
| Console |
| Assembly |
111 | Front of Bracket |
119 | |
| 73 |
119 | 113 |
73 |
|
9
