Healthrider HMTL79608.0 manual Problem Solution, Top, Walking belt slows when walked on

PROBLEM:

SOLUTION:

PROBLEM:

SOLUTION:

Locate the Reed Switch (22) and the Magnet (18) on		Top
the left side of the Pulley (17). Turn the Pulley until the
Magnet is aligned with the Reed Switch. Make sure		View
that the gap between the Magnet and the Reed			17
Switch is about 1/8 in. (3 mm). If necessary, move the		22
Reed Switch slightly using a slotted screwdriver. Next,			18
reattach the Motor Hood (not shown), making sure that		1/8 in.
the #8 x 3/4" Screws (not shown) are in the same holes
from which they were removed. Then, run the treadmill
for a few minutes to check for a correct speed reading.
The walking belt slows when walked on
a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 11.
b. If the walking belt is overtightened, treadmill perfor-	b	3–4 in.
mance may decrease and the walking belt may be-
come damaged. Remove the key and UNPLUG THE
POWER CORD. Using the hex key, turn both rear
roller bolts counterclockwise, 1/4 of a turn. When the
walking belt is properly tightened, you should be able
to lift each edge of the walking belt 3 to 4 in. (8 to 10
cm) off the walking platform. Be careful to keep the
walking belt centered. Then, plug in the power cord, in-	Rear Roller Bolts
sert the key, and run the treadmill for a few minutes.
Repeat until the walking belt is properly tightened.
c. If the walking belt still slows when walked on, see the front cover of this manual.
The console displays remain lit when you remove the key from the console
a. The console features a display demo mode, designed to be used if the treadmill is displayed in a
store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off
the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE
INFORMATION MODE on page 20 to turn off the demo mode.

23