ELECTRONIC MONITOR MODES
The
SpeedÑDisplays the number of repetitions you are performing per minute.
TimeÑDisplays the length of time you have exer- cised. Note: If you stop exercising for ten seconds or longer, the time mode will pause until you resume.
DistanceÑDisplays the total number of repetitions you have completed, up to Ò999.Ó The display will then reset to Ò0Ó and continue counting.
CaloriesÑDisplays the approximate number of Calories you have burned. Note: If the resistance is near the highest or lowest setting, the actual number of Calories you have burned will be slightly higher or lower than the number displayed.
ScanÑDisplays the speed, time, distance, and calo- ries modes, for approximately 5 seconds each, in a repeating cycle.
DIAGRAM OF THE ELECTRONIC MONITOR
1
2
3 4
OPERATING THE ELECTRONIC MONITOR
1.To turn on the power, press the on/reset button or simply begin exercising on the AEROFLYER. The entire display will appear for two seconds. The electronic monitor will then be ready for operation.
2.Select one of the five modes:
Scan modeÑWhen the power is turned on, the scan mode will be selected automatically. The scan mode can also be selected by repeatedly pressing the mode button. One mode indicator will show that the scan mode has been selected, and a second mode indicator will show which mode is currently displayed.
Speed, time, distance, or calories modeÑ These modes can be individually selected by repeatedly pressing the mode button. The mode indicators will show which mode has been select- ed. (Make sure that the scan mode is not select- ed.) The modes will be selected in the following order: speed, time, distance, calories, scan.
3.The monitor has an
To reset the LCD display, press the on/reset button.
1.LCD displayÑDisplays all modes.
2.Mode indicatorsÑShow which mode is selected.
3.Mode buttonÑSelects all modes.
4.On/Reset buttonÑTurns the power on and resets all modes.
10
