Healthrider HRAW56071 manual Storage and TROUBLE-SHOOTING, HOW to Fold the Aeroflyer for Storage

STORAGE AND TROUBLE-SHOOTING

Inspect and tighten all parts of the AEROFLYER regularly. Replace any worn parts immediately. The AEROFLYER can be cleaned with a soft, damp cloth. Keep liquids away from the electronic monitor. Keep the monitor out of direct sunlight or the display may be damaged. Remove the batteries when storing the

AEROFLYER.

HOW TO FOLD THE AEROFLYER FOR STORAGE

When the AEROFLYER is not in use, it should be folded to the compact storage position. To fold the AEROFLYER, first remove the lock knobs and lock washers from the legs. Insert the lock knobs and lock washers into the holes in the crossbar. Next, hold the resistance dials and fold the frame and the uprights together. CAUTION: When the AEROFLYER is not in use, always fold it to the storage position and unbuckle the nylon belt. Place the AEROFLYER in a location where it cannot fall.

Lock	Resistance
	Knob
Washer
Lock
Knob
Upright	Frame
Crossbar

REPLACING THE BATTERIES

If the display of the electronic monitor becomes dim, or if the monitor does not function properly, the batter- ies should be replaced. To replace the batteries, refer to assembly step 6 on page 7.

HOW TO ADJUST THE REED SWITCH

If the speed and distance modes do not display cor- rect information, the reed switch should be adjusted.

The reed switch is
located below the
electronic monitor
(see the drawing at
	Magnet
the right). Loosen the
screw in the reed
switch, move the reed
switch to the side
slightly, and retighten
		Reed
the screw. Make sure		Switch
that the reed switch
does not hit the

indicated magnet when the AEROFLYER is in use. Repeat until the speed and distance modes display correct information.

11