ASSEMBLY
Assembly requires two people. Place all parts of the AEROFLYER in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
Read through all steps before beginning assembly. As you assemble the AEROFLYER, make sure that all parts are oriented as shown in the drawings. Tighten all parts as you assemble them, unless instructed to do other- wise. Refer to the drawings below to identify the small hardware used in assembly. Note: If a part is not found in the parts bag, check to see if it has been
Assembly requires two adjustable wrenches | , a hammer | , and a phillips | |
screwdriver | (not included). |
|
|
#8 x 3/4" Screw (23)Ñ1 | #8 x 1/2" Pedal Screw (21)Ñ8 | #8 x 1/2" Handle Screw (48)Ñ4 | ||||
Plastic Spacer (41)Ñ2 | Bronze Bushing (16)Ñ4 | 3/8" Flat Washer (39)Ñ4 | 3/8" Axle Cap (40)Ñ4 | |||
3/8Ó Lock Washer (58)Ñ2 | 3/8Ó Spacer (60)Ñ2 | 1/2Ó Spacer (61)Ñ4 | 3/8" Nylon Locknut (43)Ñ2 | |||
|
| 3/8" x 4" Screw (44)Ñ4 |
|
| ||
|
| 3/8Ó x 5 1/2Ó Screw (42)Ñ2 |
|
| ||
1.Read all instructions at the top of this page before beginning assembly.
Refer to the drawing at the right and identify the Left and Right Uprights (1, 2). Note the location of the stop rods.
Turn the Crossbar (10) so the Rocker Arm (9) is at the top. Attach the Crossbar to the Left Upright (1) with two 3/8Ó x 4Ó Screws (44) and two 3/8Ó Flat Washers (39). Do not tighten the Screws yet. Attach the Crossbar to the Right Upright (2) in the same manner.
Fig. 1 | Stop |
|
| Rods |
|
|
| 2 |
1 | 10 | 9 |
39 |
|
|
44 |
|
|
5
