Razor Bistro 15130640 Assembly and SET-UP, Charging the Battery, Attaching the Handlebars

ASSEMBLY AND SET-UP

Charging the Battery

Your Pocket Mod may not have a fully charged battery; therefore it is a good idea to charge the battery prior to use.

•	Initial charge time: 12 hours	• Run time: up to 40 minutes
•	Recharge time: up to 8 hours	• Average battery life: 250 charge/discharge cycles
	depending on the level of depletion

WARNING: Always disconnect your Pocket Mod from the charger before cleaning with liquid.

Note: If your charger does not look like the one illustrated, your unit has been supplied with an alternative charger. The specifications and charging procedure would not change.

Charger

Plug

Charger

Port

1 Plug the charger port into	2 Plug the charger plug into a wall
the port on the Pocket Mod. The	outlet.
charger works with the power
switch in either the on or off
position.

The charger has a small window with one LED or two LEDs to indicate the charge status. Refer to the illustration on the charger unit for the actual “charging” and “charged” status indications for your model charger.

Chargers have built-in over-charge protection to prevent battery from being over-charged.

Be sure to properly align the groove on the charger input plug with the corresponding socket on the case; otherwise, no charging action will occur.

Attaching the Handlebars

WARNING: Failing to properly adjust and tighten the clamps and retainers that affix the handlebar can cause you to lose control and fall.

1 Insert handlebar assembly	2 Tighten down the hexagonal
through front fairing and into	bolt with the 5mm hexagonal key
fork.	wrench.

Testing the Brakes

To use the brake, squeeze the lever to increase the pressure on the brake. The brake lever is fitted with a cable adjuster to compensate for cable stretch and/or to fine-tune the lever movement to brake engagement. If brake is not engaging properly, follow instructions for adjusting the brakes outlined on the next page.

WARNING: The brake is capable of skidding the tire and throwing an unsuspecting rider.

Practice in an open area free from obstacles until you are familiar with the brake function. Avoid skidding to a stop as this can cause you to lose control or damage the rear tire.

Note: The brake lever contains a safety switch to stop the motor when the brake is applied. In an emergency, applying the brake will always stop the motor. Do not disable or replace this lever with anything other than a genuine Razor replacement part.

3