Healthrider HRAW56071 manual Tighten all parts used in steps 1, 3

2.Refer to figure 2b. Slide a Finger Guard (54) onto the pins on the Left Pivot Bracket (7). Note: The Finger Guards may already be attached.

Find the Left Link Arm (11), which is labeled with a ÒleftÓ sticker. Make sure that there is a Bronze Bushing (16) in each end of the Link Arm. Slide one end of the Link Arm onto the indicated pin on the Left Pivot Bracket (7). Slide a 3/8Ó Spacer (60) onto the same pin. Tap a 3/8Ó Axle Cap (40) onto the pin. Slide the other end of the Link Arm onto the pin on the Rocker Arm (9). (Note: It may be necessary to pivot the Rocker Arm and the Left Leg

[3]slightly.) Slide two 1/2Ó Spacers (61) onto the same pin. Tap a 3/8Ó Axle Cap (40) onto the pin.

Attach the other Finger Guard and the Right Link Arm (not shown) in the same manner.

3.Attach the Right Frame Section (6) to the Right Upright (2) with a 3/8Ó x 5 1/2Ó Screw (42), a Plastic Spacer (41), and a 3/8Ó Nylon Locknut (43). Do not tighten the Nylon Locknut yet.

4.Slide the long end of the Nylon Strap (59) onto the Right Frame Section (6) as shown. Slide the short end of the Nylon Strap (59) and the Hip Pad (28) onto the Left Frame Section (5).

Slide the Left and Right Frame Sections (5, 6) together. Make sure that the indicated hole is accessibleÑif necessary, slide the Hip Pad (28) to the side. Attach the Frame Sections with a #8 x 3/4Ó Screw (23). Do not tighten the Screw yet.

Attach the Left Frame Section (5) to the Left Upright (1) with a 3/8Ó x 5 1/2Ó Screw (42), a Plastic Spacer (41), and a 3/8Ó Nylon Locknut (43).

Tighten all parts used in steps 1, 3, and 4.

Center the Hip Pad (28) on the Left and Right Frame Sections (5, 6).

Fig. 2a			7	Pin
				16
				60
		40	11
		3
9
				Fig. 2b	7
Pin				54	Pins
	16	61	40
Fig. 3
					42
			43
			2	41	6
Fig. 4			59	6
	28
59			Hole
			23
			43
5
41
42
1

6