TROUBLESHOOTING

Most treadmill problems can be solved by following the instructions below. If further assistance is needed, please call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

PROBLEMSOLUTION

1.The power does not turn on

a.Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 8). Use only a single-outlet surge suppressor that meets all of the specifications described on page 8. Important: The treadmill is not compatible with GFCI-equipped outlets.

b.Make sure that the key is fully inserted into the console.

c.Check the circuit breaker located on the frame near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

c

Tripped Reset

2.The power turns off during use

a.Check the circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, un- plug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console and then reinsert it.

3. The walking belt

a. Use only a single-outlet surge suppressor that meets all of the specifications de-

slows when walked

scribed on page 8.

 

 

on

 

 

 

 

b. If the walking belt is overtightened, tread-

b

 

 

mill performance may decrease and the

3–4”

 

walking belt may be permanently dam-

 

 

 

aged. Remove the key and UNPLUG THE

 

 

 

POWER CORD. Using the included allen

 

 

 

wrench, turn both rear roller adjustment

 

 

 

bolts counterclockwise 1/4 of a turn. When

 

 

 

the walking belt is properly tightened, you

 

 

 

should be able to lift the edges of the

Rear Roller Adjustment Bolts

 

walking belt 3 to 4 inches off the walking

 

 

 

 

platform. Be careful to keep the walking

 

 

 

belt centered. Plug in the power cord, insert the key and run the treadmill for a few

 

minutes. Repeat until the walking belt is properly tightened.

 

25

Page 25
Image 25
Healthrider HRT15920 manual Troubleshooting, Problemsolution