Healthrider HRTL12994 manual Displays, Top Make sure that the gap between

PROBLEMSOLUTION

4.The walking belt is off-center or slips when walked on

a.If the walking belt has shifted to the left, first remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn the left rear roller adjustment bolt clockwise, and the right bolt counter- clockwise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is centered.

b.If the walking belt has shifted to the right, first remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn the left rear roller adjustment bolt counterclockwise, and the right bolt clockwise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is centered.

a

b

	c. If the walking belt slips when walked
		c
	on, first remove the key and UNPLUG
	THE POWER CORD. Using the allen
	wrench, turn both rear roller adjustment
	bolts clockwise, 1/4 of a turn. When the
	walking belt is correctly tightened, you
	should be able to lift the edges of the
	walking belt 3 to 4 inches off the walking
	platform. Be careful to keep the walking
	belt centered. Plug in the power cord, in-
	sert the key and run the treadmill for a few minutes. Repeat until the walking belt
	is properly tightened.
5. The displays of the	a. Remove the key from the console and UN-
console do not func-	PLUG THE POWER CORD. Next, remove
					1/8Ó
tion properly	the screws from the hood and carefully re-
					20		28
	move the hood. Locate the Reed Switch
								85
	(26) and the Magnet (85) on the left side of					26
	the Pulley (28). Turn the Pulley until the
	Magnet is aligned with the Reed Switch.			Top
	Make sure that the gap between the		View
	Magnet and the Reed Switch is about
	1/8Ó. If necessary, loosen the Reed Switch
	Screw (20) and move the Reed Switch slightly. Retighten the Screw. Re-attach the
	hood and run the treadmill for a few minutes to check for a correct speed reading.

6.Bubbles form in the walking belt

a.Due to variations in humidity and temperature, there is a possibility that bubbles may form in the walking belt. Although the bubbles will disappear with time, you may unplug the power cord, carefully insert a needle into the bubbles, and push the air out of the bubbles.

26